About HEAKOR Transformer
Transformer Solutions for Project-Based Power Distribution
HEAKOR supports overseas buyers, contractors, distributors, and project teams with transformer selection and quotation for power distribution applications.
The product range presented on this website includes single-phase and three-phase pole-mounted transformers, single-phase and three-phase pad-mounted transformers, dry-type transformers, and substation power transformers.
How We Handle Technical Enquiries
Each enquiry is reviewed against the customer’s electrical system, installation conditions, destination-market requirements, and project specification. Product suitability, applicable standards, tests, accessories, price, and delivery are confirmed for the specific order rather than assumed from a general catalogue page.
Information Required for a Technical Review
- Rated capacity in kVA or MVA
- Primary and secondary voltage
- Phase and frequency
- Impedance, vector group, and neutral requirements where applicable
- Transformer type and indoor or outdoor installation
- Ambient temperature, altitude, and other environmental conditions
- Applicable IEEE, IEC, utility, national, or project standards
- Required tests, accessories, protection, and documentation
- Quantity, destination country, and required delivery schedule
- Single-line diagram, datasheet, or tender specification if available
From Enquiry to Proposal
- Send the available technical and commercial requirements.
- Open points are identified for confirmation.
- A technical proposal and quotation are prepared for the defined scope.
- Final configuration follows the approved specification and order documents.
Contact HEAKOR
Use the contact form to send your transformer specification or single-line diagram. If some information is not yet available, mark it as TBC rather than guessing.